(60)
The SIMTECH RBP Series Back Pressure Regulator is designed to protect piping and equipment from pressure changes where a constant regulated pressure on the up stream side of the valve is required. Prevents pumps from dead heading, over pressurization, pressure surge conditions, and maintains back pressure in closed loop systems.
Adjustable screw and lock-nut makes it easy to accurately preset desired up-stream pressure.
Teflon (primary) and EPDM (back-up) diaphragms standard.
No metal contact with fluid.
Wide adjustable pressure range (10-125 PSI)
Small pressure differential band from cracking point to fully open, and from fully open to close.
(42)
The SIMTECH RMD Series Modular Wet Bench Dump valve features a compact design that is made to be cemented or welded to the bottom panel of the sink. It is remotely operated with a 3-way (for type 1) or 4-way (for type 2) control valve. It is used to replace trap doors and air cylinders in rinse tanks, etch modules, etc., with no leakage or alignment problems, for less than the cost of a trap door and its required hardware and installation.
Dynamic seal o-rings are Teflon encapsulated Viton for long life and trouble free operation.
It is designed so that the main component can be removed from the installation for easy maintenance and repairs.
(6)
The SIMTECH RAP is an adjustable pressure switch with a multitude of uses. This switch may be used to open or close valves, start or stop pumps, sound alarms or limit pressure in tanks. The switch can be wired either normally open or normally closed for either rising pressure or falling pressure.
This patented switch is designed so there is no metal contact with the fluid.
A Viton diaphragm is used to isolate corrosive chemical fluids from the switching mechanism.
It has a ½” FPT conduit inlet and ½” FPT mounting on the bottom center.
All pressure switches are factory pre-set and are adjustable to your needs by rotating the top set screw.
(NOTE: on PVDF pressure switches, mounting base only is ...
(4)
Liquid Level Float Switch (RLF)
The SIMTECH RLF Series Liquid Level Float Switch is a compact device ideal for maintaining liquid levels in tanks by activating relays or solenoids which can open or close a valve, sound high or low level alarms, turn heaters and pumps on or off or to light panel mounted indicator lights. It can also be mounted near the bottom of a drum to signal when it is nearly empty. The CPVC stem houses a 1amp 115 VAC reed switch and the polypropylene float is suitable for temperatures to 180 degrees F. 12” extensions with couplings allow this versatile device to be used in most any size tank.
Longer extensions are also available.
A CPVC mounting bracket is available for easy mounting. Other ...
