The WeldTech^® MINIPLAST 2 is a welding machine for the heating element butt welding of PE, PP and PVDF pipes and fittings from 20mm OD to 110mm OD. The basic machine has two large aluminum basic clamping tools which are swiveling 15° on each side for the fabrication of segmented bends. By screwing in 4 small reduction clamping inserts, a double clamping is obtained at the smaller diameters. For fittings with short legs, a small fitting clamping tool is available. Due to the special construction of the pressure build-up device, the machine can be fixed directly at very short pipe ends on walls and sheets. Due to its light and compact construction, the machine is ideally suited for use in the pipeline system and for assembly work. In the case of stationary use, the machine can be fixed in the vice or at the table support. In addition; an extended version for the fabrication of T-pieces and elbows 90° (up to 90 mm) is available. On both sides, each basic clamping tool can be swiveled up to 45°. This basic machine is vertically and horizontally adjustable. The light and compact manual face cutter is operated by means of a ratchet. The electronically adjusted heating element in accordance with DVS 2208 (110v/) has a diameter of 120mm, an anti-stick coating and control lamps for system and interval checking. For the safe storage of the face cutter and the heating element, a heat-protected box is available. The Sturdy Wooden Transport case serves for the transport and the protected storage on the complete WeldTech ^® MINIPLAST 2.